Got loads of grommets but they’ve got holes in.Or put a rubber gromet in the hole.
I’ll pick up a pack of blanking type ones.
Got loads of grommets but they’ve got holes in.Or put a rubber gromet in the hole.
The same 90/90 and 100/90 as well? people do seem to rave about them.That is what I have 21/19 with Avon Road Riders, the AM26 version. I'm very happy with them.
Yes, I meant to say that as well.The same 90/90 and 100/90 as well? people do seem to rave about them.
The rims I just re-tyred had 4 holes per rim. One for the valve stem, two for the rim locks and one for a balance weight. I made 3 little button head alloy bushings and pushed them in from the inside of the rim, with and appropriate bit of filing to come close to the contour of the rim and set them in there with black silicone and then covered with the rim tape. You can barely see them sitting there between the spokes. Certainly much less so that rim lock and weight bolts.Thanks.
Didn’t know they were fitted originally.
Might as well fit it back on otherwise there’ll be a hole there.
I opted for the same setup two years ago and have done about 2000mls since (1500 with the JE Mod).I was looking at 90/90 up front and 100/90 in the rear, would that cause any issue or are there other sizes I should consider??