On a tool web site, this is described as an early K1 Vincent spanner, "Correct and genuine tool for earlier models, much rarer than later 12 point tools".
Does anyone know if that's true or not?
Thanks guys (he says tongue in cheek) but it doesn't really answer my question.
Does anyone know if this spanner pre-dates the 12 point version and was it supplied with earlier model Vincents?
A little humour is good but not very informative.;-)
Take a look at the link below. It shows an early MO33 parts book illustration of the Vincent tool kit. It shows a 6 point K1. If we assume that the parts book shows what was supplied then you have your answer. The same 6 point K1 is shown on"C" and "D" parts drawing at the main club site. Is the far superior 12 point version perhaps something developed by the VOC Spares Co? http://coventryvoc.co.uk/parts_list_drawings/m033.htm
Thanks guys (he says tongue in cheek) but it doesn't really answer my question.
Does anyone know if this spanner pre-dates the 12 point version and was it supplied with earlier model Vincents?
Ed
While the MO drawings are indicative of the "start point" I never felt they are much good for picking out the "stop point" for components or tool design changes, one only has to look at the gearchange picture to see that they were not updated often. As far back as I bought Vincent tools they have always been 12 point even the 'Canada one' with the corkscrew attched was 12 point -Which since to me wine is what tranmissions do when the dynamo sprocket is too far in, I found is used for getting rubber bungs out of crash bars
K.T.B. clearly states that early machines had a single hexagon spanner. I had a bit of fun a couple of years ago and made one for a local member stamped "K.J." 1 as these are his initials. This should cause some debate long after I have ceased caring!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.