C: Clutch ET 38 Clip On Clutch Shoes

[Bogage]

I see some hints on install, but I am having a heck of a time removing these darned things. My shoes need to be rebutted on the pivot and I'm trying to get them out without removing the entire carrier as it is oil tight at the moment!!

Insight is desired gentlemen, I am a rookie, only owned my bike 11 years

 

[Bogage]

Sorry, they need to receive bushings...

 

[bmetcalf]

I assume you are using circlip pliers.

 

[Bogage]

It's the baby ones Bruce, I got the circles off, it's the baby one's ET38. I am trying to get the shoes off without removing the carrier. but perhaps I cannot?

 

[Bogage]

circlips, god do I hate spell check

 

[timetraveller]

An instrument screw driver, flat headed, pushed into one of the gaps and gently levered. Do it as near as possible to the open end. You might need two, one to lever and one to hold the circlip out away from the back.

 

[bmetcalf]

Do you have some sort of lever to gently pry the shoes off the posts? Can you post a photo?

 

[Bogage]

I’m going to remove the shoe assembly, thought I could get the shoes out without doing so

 

[Bogage]

Got it!

 

[bmetcalf]

You must have removed the center nut. I normally remove the shoes as an assembly with the C13.