Can someone please help me out and measure the vertical distance between the holes on the F106 frame tie that connect the UFM to the G50/1 and the inner comet chaincase? (Not the footrest hanger holes). As I mentioned in another thread, I will be fabricating something to replace the frame tie and that distance is important for correct geometry and I don't have a frame tie here to measure. In the picture this would be the distance from the 3/8 rod in the inner chaincase and G50/1 to the rear head mounting hole in the UFM.
I have used a standard muff in this picture because the cases have not been bored yet, and it and the standard comet G50/1 plate are just there for mock up. The oil filler tube location and angle is different than David's other frames, since I want to use an aluminum Egli tank I picked up that may be from a Ducati or Honda with a wet sump and no cut for a regular Egli filler neck. It has a few small dents that I need to get to at some point.
Thanks,
Ron
I have used a standard muff in this picture because the cases have not been bored yet, and it and the standard comet G50/1 plate are just there for mock up. The oil filler tube location and angle is different than David's other frames, since I want to use an aluminum Egli tank I picked up that may be from a Ducati or Honda with a wet sump and no cut for a regular Egli filler neck. It has a few small dents that I need to get to at some point.
Thanks,
Ron
Last edited: