Tank bolt spacer & tie rod
I always use a piece of alloy bar (round or hex) just wide enough to take a 1/4 BSF tapped hole both ends then add a short 1/4 BSF hex set screw & washer each end lighter and narrower especially if you have jacked the rear up one rubber FT172/1
The one i've made up is a piece of 1/4 s/s tube with a 1/4 s/s body washer at each end, then a 6mm stud through with a s/s body washer and nyloc's on the outside.
Chris.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.