Hello,
Just run a distributor in the lathe, with new club shop springs is is aground 700 RPM. With some heaver springs it was around 1000 RPM.
This later figure is a little high I feel, as it would be 2000 RPM of engine speed.
Regards John.
Hello,
Just run a distributor in the lathe, with new club shop springs is is aground 700 RPM. With some heaver springs it was around 1000 RPM.
This later figure is a little high I feel, as it would be 2000 RPM of engine speed.
Regards John.
Hi John, That's interesting, my Pazon doesn't reach full advance until about 4000 engine rpm according to the graph supplied with it - perhaps that's why I'm running 42 degrees at full advance.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.