• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Series D timing advice

macvette

Well Known and Active Forum Website User
Non-VOC Member
Can anyone tell me at what engine RPM the series D distributor is at full advance?

Thanks Mac
 

john998

Well Known and Active Forum Website User
VOC Member
Hello,
Just run a distributor in the lathe, with new club shop springs is is aground 700 RPM. With some heaver springs it was around 1000 RPM.
This later figure is a little high I feel, as it would be 2000 RPM of engine speed.
Regards John.
 

Howard

Well Known and Active Forum Website User
VOC Member
Hello,
Just run a distributor in the lathe, with new club shop springs is is aground 700 RPM. With some heaver springs it was around 1000 RPM.
This later figure is a little high I feel, as it would be 2000 RPM of engine speed.
Regards John.

Hi John, That's interesting, my Pazon doesn't reach full advance until about 4000 engine rpm according to the graph supplied with it - perhaps that's why I'm running 42 degrees at full advance.

H
 

davidd

Well Known and Active Forum Website User
VOC Member
I think the new BT-H is 3200 rpm full advance. The timing at 19 degrees (twin plugs.)

David
 
Warning! This thread is more than 11yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top