The front H25/2AS spindles on my two Vincent series C's use standard 1/2 inch BSF nuts (part number 507) with standard A/F of 0.825 inches.
There appears to be too much clearance between the "flat" of the nut and the recessed "ledge" at the bottom of the right hand side of the girdraulic blade. This has caused quite an indentation in the "ledge" of both blades. Perhaps this has been caused over the last 58 years by enthusiastic over-tighnening. It appears to be a minor design fault.
Does anyone know whether this apparent fault has been corrected by the VOC drawings project and therefore for the new girdraulic blades being manufactured by the VOC spares company?
Cheers
Vic
There appears to be too much clearance between the "flat" of the nut and the recessed "ledge" at the bottom of the right hand side of the girdraulic blade. This has caused quite an indentation in the "ledge" of both blades. Perhaps this has been caused over the last 58 years by enthusiastic over-tighnening. It appears to be a minor design fault.
Does anyone know whether this apparent fault has been corrected by the VOC drawings project and therefore for the new girdraulic blades being manufactured by the VOC spares company?
Cheers
Vic