• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Fuel Tank Spout

ogrilp400

Well Known and Active Forum Website User
VOC Member
Dear All,
Does anyone know if and if so where petrol tank spouts are available as a separate items? I have a Vincent tank that has the spout welded too low on the inner edge. This means that the cap edge hits the tank before it seals down on the top lip. I need a spout.

Phelps.
 

Bill Thomas

Well Known and Active Forum Website User
VOC Member
Hello Phelps, If you have weld it anyway, Could you not just cut it and weld a small ring in between, Or get another, Cheaper british tank and cut the spout off it, Good Luck, Bill.
 

b'knighted

Well Known and Active Forum Website User
VOC Member
I bought one on eBay but cannot see them listed at the moment. A local welder with whom I was discussing the modification of an Indian tank told me that they are available in stainless and suggested welding that into a mild steel tank as chipping in use is then less of a problem.
 
Warning! This thread is more than 9yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top