• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Comet's ET84

Michel

Well Known and Active Forum Website User
VOC Member
Hello everybody,

Does the nut ET84 chrome-plated, cadmium-plated or natural bronze ? I read "Know thy Beast" but didn't find the right reply.

Thanks a lot. Michel.
 

timetraveller

Well Known and Active Forum Website User
VOC Member
Natural bronze for all the ones I have seen but wait until others have responded as well to get a consensus. If you do decide to plate do not do the threads.
 

vibrac

Well Known and Active Forum Website User
VOC Member
You can have them chrome plated. I have a set in Electrolised nickle as this gives an even cover over sharp corners. As for plating the thread, that depends on the clearance before plating. I have known plating done specifically to tighten a sloppy fit-again in electrolised Nickle
 
Warning! This thread is more than 12yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top