Whilst fitting a new clutch cable I dropped and lost somewhere under floor boards of the shed, part number 331X out of the Burman clutch lifting mechanism. The hex headed adjusting bush. I purcased another from the spares company but on fitting it I now cannot get the little outer cover, 328X, back on flush. There is a 3mm gap even with the new bush screwed in as far as it will go! Is there a chance that the original 331X was 3mm shorter than the new one or could anything else have moved down by the lever pivot.
I won't have a chance to take off the cover until next weekend now and I've not had it apart before but from the illustration it looks simple enough. Is there anything I should be looking for especially?
thanks
Dave
I won't have a chance to take off the cover until next weekend now and I've not had it apart before but from the illustration it looks simple enough. Is there anything I should be looking for especially?
thanks
Dave