• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Twin Pivot Plate G50 thickness?

minivin

Well Known and Active Forum Website User
VOC Member
I'm in the process of "jigging" the Egli frame on to the twin engine that I am building, but I do not have a G50 plate, as I am awaiting an electric start from Francois. Could someone let me know what the thickness is?

I'm trying to get the swingarm in and determine what offset I need for the rear wheel (I got caught out on the last build for my Egli-Comet!).

Rob
 

davidd

Well Known and Active Forum Website User
VOC Member
Hello, Have measured 3, 2 at .310" one at .324" Could be 8mm or 5/16". So Vincent. Regards John.

I know the Comet and Flash G50s that I have measured in the past have been 5/16" and so were the footrest plates on the Flash and Lightnings, so I suspect they used that thickness on many of the parts.

David
 
Warning! This thread is more than 9yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top