• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Rfm

W Miller

New Forum Website User
Non-VOC Member
I am V.O.C. member in Ohio in U.S.A.
i am straightening C Series RFM. I made a fixture to hold it. My question is - Are rear axle castings, front pivot casings, and castings for spring units, center line as viewed from above or are these offsets?
A mechanical drawing or even a a sketch would be great .
Bill Miller
 

clevtrev

Well Known and Active Forum Website User
VOC Member
The centreline of the rear axle castings are offset to the pivot casting. By 9/16" to the left, as viewed from above, from the rear of the machine. 8 5/8" between those rear castings.
 

W Miller

New Forum Website User
Non-VOC Member
Hello Clevtrev,
Thanks for your help-I had an opportunity to check another RFm yesterday-confirms your info.
Best regards,
W.K.M.
 
Warning! This thread is more than 13yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top