• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Pre monobloc

alistairmcg67

Forum Website User
Non-VOC Member
Good afternoon

I have just fitted a new pre monobloc to my Comet and it insists on flooding from the body of the carb. Why is it doing this?:(
 

Tnecniv Edipar

Well Known and Active Forum Website User
VOC Member
There is a problem with the float needle valve. Check that the float is free and that the needle is seating properly on it's seat.
 

alistairmcg67

Forum Website User
Non-VOC Member
thanks... looking again at the float needle there are two positions to clip the float height, if i choose the lower of the two the flooding stops...
 

John Appleton

Well Known and Active Forum Website User
VOC Member
Hello Alistair, I have nothing to say about your kickstart, just wanted to say "hello, long time no see" and I am pleased you are still about. John
 
Warning! This thread is more than 13yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top