• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Norvin

pegmac910

New Forum Website User
Non-VOC Member
I Would Like To Put A Comet Engine Burnham Gearbox Into A Slim Line Frame. Are There Any Engine Plates Available Or Does Any Member Have Any Pattern I Could Beg, Borrow Or Buy? Many Thanks For Any Assistance In Advance. David
 

manxnortonman

Well Known and Active Forum Website User
VOC Member
David,
I have a photostats of the plates I made for the 500cc Norvin I built using a Norton laydown box. I believe the mounting lugs on the gearbox are the same. If you want a copy e mail me or call 07952866193 and I will run you off a set.​
Regards Garry Laurence
manxnortonman@yahoo.co.uk
 
Warning! This thread is more than 15yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Photos from the 2022 North American Rally

Photos from the 2022 Far Far North Rally

Photos from the 2022 Annual Rally

Photos from the 2022 French Rally


Top