Misc: Ignition Fitting ATD

[Scout63]

Buttoning it up and hopefully a first start today Graham. I’ll try to post a video.

 

[Scout63]

Still sorting. It was great getting everything fitted up, but then it wouldn’t start. Fuel to the carbs just fine and spark on both plugs. I think I have the timing off. Back into it this week.

 

[Bill Thomas]

One thing I found , If the taper on the shaft sticks out beyond the edge of the hole,
in the ATD, The long nut can become thread bound, Before being tight on the taper,
We are only talking a very small amount !,
I drilled up the long nut, Only a tiny amount, So the end of the taper went inside the long nut.

 

[Scout63]

Finally started today. Thanks everyone for your help.