• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

factory paint

Bracker1

Well Known and Active Forum Website User
VOC Member
I am about to paint my Shadow's engine a 2pack urethane, and had a quick question. Did the factory spray the bike engine assembled or in pieces? I noticed drip marks inside the engine case indicating it was apart when spray, but my engine has had a hard life, and may have been resprayed at some point. Thanks, Dan
 

david bowen

Well Known and Active Forum Website User
Non-VOC Member
paint

Factory, the crankcase where bolted together in mating pairs all holes blanked then dipped in to tank of I think pinching and Johnson enamel hang up to drain then put in a heated oven,
 
Warning! This thread is more than 13yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top