I have a fitting made up that will go into the space occupied by the 1BA bolt in the arm that holds the float bowl. It is a 90
degree affair I'm hoping will fit in between the front cylinder fins and the carb, and pretty sure I can take out the battery in the
rear to install it.
Having never measured the float level previously I need some assistance. One post says the "float level at the top edge of the float
measured at the edge away from the needle and seat should be .080" below the top edge of the float." So do I hook up my line, take off the top of the float bowl and try to measure .080"? Another says 'ensure the clear tube is against the banjo nut, not the float bowl. If the level is somewhere in the middle to upper part of the top band of the banjo, it passes the test."
So, suggestions solicited.
I''ll replace the needles, do my best to check the floats and start over once again if necessary.
degree affair I'm hoping will fit in between the front cylinder fins and the carb, and pretty sure I can take out the battery in the
rear to install it.
Having never measured the float level previously I need some assistance. One post says the "float level at the top edge of the float
measured at the edge away from the needle and seat should be .080" below the top edge of the float." So do I hook up my line, take off the top of the float bowl and try to measure .080"? Another says 'ensure the clear tube is against the banjo nut, not the float bowl. If the level is somewhere in the middle to upper part of the top band of the banjo, it passes the test."
So, suggestions solicited.
I''ll replace the needles, do my best to check the floats and start over once again if necessary.