The Spares Company
Club Shop/Regalia
Parent Website
Contact Officials
Machine Registrar
Club Secretary
Membership Secretaries
MPH Editor and Forum Administrator.
Section Newsletters
Technical Databases
Photos
Home
What's new
Latest activity
Forums
New posts
What's new
New posts
Latest activity
Information
Bike Modifications
Machine Data Services
Manufacturers Manuals
Spare Parts Listings
Technical Diagrams
Whitakerpedia (Vincent Wiki)
The Club
MPH Material Archive
Flogger's Corner
Obituaries
VOC Sections
Local Sections
Local Section Newsletters
Miscellaneous
Club Assets
Club History
Club Rules
Machine Data Services
Meeting Documents
Miscellaneous
Essential Reading
Magazine/Newspaper Articles/Letters
Adverts and Sales Brochures
The Mighty Garage Videos
Bikes For Sale (Spares Company)
Log in
Register
What's new
New posts
Menu
Log in
Register
Install the app
Install
Home
Forums
Forums: Public Access
Tech. Advice: Series 'B' / 'C' 500cc/1000cc Bikes
Gearbox oil level rising/Primary falling
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tim welsh" data-source="post: 54920" data-attributes="member: 172"><p>Update on findings after stripping the primary:</p><p>Found the orange silicon I had put over the head of crankcase stud K had gone, so could explain loss of primary case oil (was leaking from near gearchange cover )(usual very relevant question Trev!), Re siliconed it.</p><p>Retaining ring for bearing in gearbox cover plate only finger tight (but split pins still in place). Tightened and loctited.</p><p>Replaced G24 seals in my crank seal, and in coverplate, both gone a bit hard.</p><p>Replaced 5 broken inner esa springs.</p><p>Gearchange pawl spring broken, explains slightly sloppy change recently.</p><p>Done 50mile test run, all back to "normal", levels ok so far. No idea how gearbox level went up!?</p><p></p><p>Glad you got back OK Alan and Judy, at least you had a centre stand for changing tyre?</p><p>Hello Vincent- are you going to Austria this year?</p></blockquote><p></p>
[QUOTE="tim welsh, post: 54920, member: 172"] Update on findings after stripping the primary: Found the orange silicon I had put over the head of crankcase stud K had gone, so could explain loss of primary case oil (was leaking from near gearchange cover )(usual very relevant question Trev!), Re siliconed it. Retaining ring for bearing in gearbox cover plate only finger tight (but split pins still in place). Tightened and loctited. Replaced G24 seals in my crank seal, and in coverplate, both gone a bit hard. Replaced 5 broken inner esa springs. Gearchange pawl spring broken, explains slightly sloppy change recently. Done 50mile test run, all back to "normal", levels ok so far. No idea how gearbox level went up!? Glad you got back OK Alan and Judy, at least you had a centre stand for changing tyre? Hello Vincent- are you going to Austria this year? [/QUOTE]
Insert quotes…
Verification
The Series 'A' Rapide was known as the '********' Nightmare?
Post reply
Home
Forums
Forums: Public Access
Tech. Advice: Series 'B' / 'C' 500cc/1000cc Bikes
Gearbox oil level rising/Primary falling
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top