• Welcome to the website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Hon. Editor and Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this website.

    If you have previously registered to use this forum, you should log in now. CLICK HERE.

    If you have never registered to use this website before, please CLICK HERE.

vincent factory

david bowen

Well Known and Active Website User
Non-VOC Member
sent p m was my bike hand built yes in the engine section only had one electric tool a Black and Decker valve seat grinder the flywheels where pressed together with a fly press. cycle assembly had one pedestal drill used to drill the bottom of the Brampton forks to fit EI28 mills pin and to help George Baker to fit the mag cowls he also had a grinder and a electric sanding belt, all hand drill where air driven, there was a little problem with them keeping water out of the system.
 

Latest Forum Threads

Can't Find What You Need?

Buyer Beware: Fake or Real?

Top