• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

UFM drawing

vincentbob

Forum Website User
Non-VOC Member
I am currently building a comet engined special (probably wont be that special) and need to construct an upper frame member including oil tank, pretty much like the standard item on my comet, but with welded on headstock tube and different rear suspension mounting.
To make my drawing more accurate I would like to get a drawing of the proper item, with hole centres, diameters etc.
I could take the tank off my comet and try to measure that, but a drawing would be much better. I seem to remember seeing a skecth of one somewhere, perhaps in an old copy of MPH, but I can't find it.
Any help would be appreciated.
Many thanks.
 

Hugo Myatt

Well Known and Active Forum Website User
VOC Member
Probably not a great help but the side elevation drawing, page 6 of the Rider's Handbook is reputed to be very accurate.
 
Warning! This thread is more than 15yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top