E: Engine This is where some of that swarf ends up.

Bill Thomas

Well Known and Active Forum User
VOC Member
You say standard flywheels are soft,
But when I got Tony Maughan to take a 1/4" off the sides of mine ,
He said how hard they were !!, What I had done a few years before,
Was to get George Brown to fit a Big Pin and
while he was doing it get the wheels Polished ! ,
Tony said that's what made it so hard.
 

Cyborg

Well Known and Active Forum User
VOC Member
Am I correct in assuming the mills pin goes in (and out) from this side? Never taken one out before. The parts book suggests it goes in from the other side, but doesn’t seem to look that way on the actual crank. (Not the bearing, but factory mills pin)


AACFB678-8950-4CAA-984C-FDB4FD870AEB.jpeg
 
Last edited:
Top