• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Series A Measurements

A_HRD

Well Known and Active Forum Website User
VOC Member
Could anyone out there with a std Series 'A' give me a couple of length measurements please? Both relate to the prop-stand casting to the rear of the primary chaincase.

1. Looking at the 9/16" dia prop-stand pivot-pin, what is the length from the face of the casting to the centre of the cross-drilled split-pin hole?
2. Looking at the 5/16" dia prop-stand spring anchor pin, what is the length from the face of the casting to the spring-groove on the pin?

Peter B
Bristol, UK.
WANTED - Series 'A' Front Frame
 

Simon Dinsdale

VOC Machine Registrar
VOC Member
VOC Forum Website Moderator
Hello Peter

1. Pivot pin length casting to cross hole 1.65" (original pin).
2. Spring anchor pin length- casting to groove centre 2" (home made pin).

Measurements taken of a 1937 Comet.

Did you get chance to look at the BSA battery carrier?

Cheers
Simon
 

A_HRD

Well Known and Active Forum Website User
VOC Member
Thanks Simon, that's perfect. Another job I can get on with :)

(We emailed separately about the battery carrier…)

Peter B
Bristol, UK.
WANTED: Series 'A" Front Frame
 
Warning! This thread is more than 8yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top