Hi Greg
Here is a snap of my levers. Complete with square head screws. Fitted to 39 meteor
John
Sorry should have said hi Andy not Greg
Hi Greg
Here is a snap of my levers. Complete with square head screws. Fitted to 39 meteor
John
Ok with regards to the two HRD cover/inspection plates that go over the clutch center and the magneto pinion drive.......should the background be black or the same burgundy/red as the top/bottom of the fuel tank..........? Also with the alloy oval spacers that go either side of the gearbox mounts, I have one original here which is 1/2 inch thickness, should the bottom one be the same. If so I am missing one and I will get some made. They will be made from solid alloy and I will drill/tap the small locator dowel using a short shank bolt arrangement rather than the original cast in dowel which is fragile, this original one is broken off. If anyone needs any let me know as I will probably make up a small batch of 10................Also are any of you in need of the cylinder hold down studs and long matching 3/8 CEI tube nuts to go with same, as I might get a small batch of these made soon as well................Can someone tell me what the lower thread that goes in the upper case is, is it 7/16 Whitworth..............Any help much appreciated...............Cheers........Greg.
They are castings brazed on the tube.Thanks John, On your lower stay/stand at the front where it bolts to the bottom of the forks, are they small machined castings that are brazed into the tube, or are the tubes just pressed flat and holes drilled through. Cheers...............Greg.