FF: Forks Raised Handle bar

Vincent Brake

Well Known and Active Forum User
VOC Member
Hi Guys,
i am in desperate search for a touring style bar, just say 2"-3"inch higher.
same angle as normal (seen from Top) bit more swept back is ok
and about 29" (74 cm) wide, but one could weld that on...

oh and the middle about 6"-3/8" apart (brampton)

I Holland unobtainable....
what motorcycle make would fit this description? so i can buy off the shelf?

i can NOT find one site doing up a good discription, only a make 'n type, (and sorry only into vinnies, so know shit about rest)

Norton?

thanx for your remarks.
 

Bill Thomas

Well Known and Active Forum User
VOC Member
I use Triumph ones, From Armours, Not sure what bike, For my bad back !. Cheers Bill. 002 (1).JPG
 

Bill Thomas

Well Known and Active Forum User
VOC Member
Sorry, Are "B" s 1", Thought that was only "A" s, Mind you Vincent is a clever lad, I sure he could make them fit.
Cheers Bill.
 

Bill Thomas

Well Known and Active Forum User
VOC Member
Hi Guys,
i am in desperate search for a touring style bar, just say 2"-3"inch higher.
same angle as normal (seen from Top) bit more swept back is ok
and about 29" (74 cm) wide, but one could weld that on...

oh and the middle about 6"-3/8" apart (brampton)

I Holland unobtainable....
what motorcycle make would fit this description? so i can buy off the shelf?

i can NOT find one site doing up a good discription, only a make 'n type, (and sorry only into vinnies, so know shit about rest)

Norton?

thanx for your remarks.
Just checked, Only 6" in the middle. Cheers Bill.
 

vibrac

Well Known and Active Forum User
VOC Member
You could always cut in half and insert a brazed tubular spacer Thats what I did on my Trials Vincent I did have internal butt ends on the joining spacer giuilding the lilly a bit -but thenI have a lathe
 

Comet Rider

Well Known and Active Forum User
VOC Member
Hi Vincent,
I have just checked both my Comet and Rapide for you.
Comet has Norton bars, a 2" raise, but only 6" in the centre
Rapide has AMC bars, a 1.5" raise, but only 6" in the centre

Try looking for trials bars, as they are usually much wider in the centre

HTH
Neil
 

Martyn Goodwin

Well Known and Active Forum User
Non-VOC Member
Hi Guys,
i am in desperate search for a touring style bar, just say 2"-3"inch higher.
same angle as normal (seen from Top) bit more swept back is ok
and about 29" (74 cm) wide, but one could weld that on...

oh and the middle about 6"-3/8" apart (brampton)

I Holland unobtainable....
what motorcycle make would fit this description? so i can buy off the shelf?

i can NOT find one site doing up a good discription, only a make 'n type, (and sorry only into vinnies, so know shit about rest)

Norton?

thanx for your remarks.
Try V3 - Neal Videan may be able to help - BUT he is at the NZ Rally ay present
 
Top