How would we repair this thread beyond repair,
well theres still a round hole, no broken bits but, it wont hold a plug anymore
I was thinking doing the normal 1-1/4 20TPI 55 degree (31.75 x 1,27mm)
up
by an M33x 1,25 mm (drill is 31.75.) put on the tap a pilot of oilpump diameter)
than again that would be a special........
Any ideas, or ready knowledge, easyer way??
Cheers
well theres still a round hole, no broken bits but, it wont hold a plug anymore
I was thinking doing the normal 1-1/4 20TPI 55 degree (31.75 x 1,27mm)
up
by an M33x 1,25 mm (drill is 31.75.) put on the tap a pilot of oilpump diameter)
than again that would be a special........
Any ideas, or ready knowledge, easyer way??
Cheers