Hi all, I have been looking at my new cams, old cams, new and old cam spindle.....I noticed (on the old cam and spindle) that at a certain point in the cam rotation, the hole in each of the cam faces lines up with its respective oil feed hole in the cam spindle.
With the new spindle and the new or old cam, at no time do the holes align and with one of them it is not even close.
I was therefore given to thinking could this be the cause of premature wear of the cam and/or followers as noted by some members.
I understand that some oil will reach the cams by various other means but is that enough?
My apologies If this has been covered elsewhere in the forums but I have not yet found it.
Kevin
With the new spindle and the new or old cam, at no time do the holes align and with one of them it is not even close.
I was therefore given to thinking could this be the cause of premature wear of the cam and/or followers as noted by some members.
I understand that some oil will reach the cams by various other means but is that enough?
My apologies If this has been covered elsewhere in the forums but I have not yet found it.
Kevin