Spent the weekend installing the new wiring loom that I got from VOC Spares on my 1950 Comet. The fit is excellent and even though the wiring diagrams and instructions and the references that I have (Richardson, Riders Handbook, et al) seem to be contradictory, I think I figured out this MES (Mysterious Electrical Stuff), at least for the front of the bike.
When it comes to the Miller D6 Dynamo and the Lucas Regulator, I am not so sure. The Dynamo has two terminals under the end cover, labeled D and F, not three as shown on the wiring diagram in the references. I wired these two outputs to the D and F terminals respectively on the Lucas Regulator. On the Lucas Regulator, there are four terminals, labeled D, F, A, and E. D and F we discussed previously, E I assume is for ground (earth) and A is, I am assuming the output from the regulator to the bike's electrical system. This is consistent with the home made loom that I removed.
Am I ok with this?
Thanks,
Charlie
When it comes to the Miller D6 Dynamo and the Lucas Regulator, I am not so sure. The Dynamo has two terminals under the end cover, labeled D and F, not three as shown on the wiring diagram in the references. I wired these two outputs to the D and F terminals respectively on the Lucas Regulator. On the Lucas Regulator, there are four terminals, labeled D, F, A, and E. D and F we discussed previously, E I assume is for ground (earth) and A is, I am assuming the output from the regulator to the bike's electrical system. This is consistent with the home made loom that I removed.
Am I ok with this?
Thanks,
Charlie