Hi There,
I am in need of the design measurement for the taper on a magnet.
am Doing an axle for it and want to do it the original way, instead of foulty machining setting the cross slide angle by a dail G. set under or over C.line.
it must be pretty obvious, but here over the small pond we dont know. is it near 1:10?
Regards and thanx for any awnser,
Vincent
I am in need of the design measurement for the taper on a magnet.
am Doing an axle for it and want to do it the original way, instead of foulty machining setting the cross slide angle by a dail G. set under or over C.line.
it must be pretty obvious, but here over the small pond we dont know. is it near 1:10?
Regards and thanx for any awnser,
Vincent