• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Location of transfers on "C" tank

Bazlerker

Well Known and Active Forum Website User
VOC Member
Are there definitive measurements for the location of the 3 transfers on a "C" tank?
 

Tnecniv Edipar

Well Known and Active Forum Website User
VOC Member
I'm sure I've seen something about this on the forum :confused:
When I had my tank refinished I ensured the original locations were used as the bike was totally untouched from the day it was made.
 

wparr2

VOC Hon. Technical Officer
VOC Member
Lines on tank

If you are a member of the VOC just go to
www.voc.uk.net and login

Select Throwing Light under Articles
Select Fuel tanks gold line and transfers

and you will be presented with the article by F. Griffin
complete with diagrams
 

Comet Rider

Well Known and Active Forum Website User
VOC Member
Tank transfers

Hi,
Measurements did'nt always seem to apply in the factory.
I have seen pic's of a Shadow 2 days after it left the factory, and there was 1" difference verticaly between the 2 sides:D Must have been a Friday afternoon bike:rolleyes:

Neil
 

Bazlerker

Well Known and Active Forum Website User
VOC Member
I am a member, but I have forgotten my password, and can't figure out how to reset it..
 

Bazlerker

Well Known and Active Forum Website User
VOC Member
With many thanks to quick admins who e-mailed me my password I was able to get into the members section of the forums...and find the section on transfers..but I cannot print the pafe "you do not have sufficient permission"..I have tried saving it as a .jpeg..again no luck..
Now I understand why this is so - it is to prevent the unauthorized copying of the material...but how in the devil am I to get this information to the person painting my tank?..
 

Bazlerker

Well Known and Active Forum Website User
VOC Member
Many Thanks to the webmaster for sending me a copy...Bruce Metcalf and Tony Cording for also sending me copies...an embarrassment of riches..
 
Warning! This thread is more than 13yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top