Hold your Head

[powella]

Sitting here on this ex-milking stool ( repaired ) I was horrified to see some Gentleman holding a Cylinder Head by the Spark Plug hole. Now if this thread strips there is major expense ahead , so this was made out of bits of scrap. The holes in the Cylinder head were used to " spot through " drilled and tapped .It is important that the holes are drilled vertical and parallel , otherwise they will not enter the head holes.No dimensions are given since it depends on what scrap , " sorry " stock you have.

 

[vibrac]

Well I have always used the LH sparkplug hole the one I have the decompressor in. Apart from anything else I often work inside the head chamber ie upside down

 

[Chris Launders]

Well I have always used the LH sparkplug hole the one I have the decompressor in. Apart from anything else I often work inside the head chamber ie upside down

That must be uncomfortable !!!!

 

[powella]

O.K.Thanks for your reply.Have taken 2 more photo`s .

Regards Alan.

 

[Normski]

I needed something like this whilst playing tiddlywinks with fitting ET38's