The Spares Company
Club Shop/Regalia
Parent Website
Contact Officials
Machine Registrar
Club Secretary
Membership Secretaries
MPH Editor and Forum Administrator.
Section Newsletters
Technical Databases
Photos
Home
What's new
Latest activity
Forums
New posts
What's new
New posts
Latest activity
Information
Bike Modifications
Machine Data Services
Manufacturers Manuals
Spare Parts Listings
Technical Diagrams
Whitakerpedia (Vincent Wiki)
The Club
MPH Material Archive
Flogger's Corner
Obituaries
VOC Sections
Local Sections
Local Section Newsletters
Miscellaneous
Club Assets
Club History
Club Rules
Machine Data Services
Meeting Documents
Miscellaneous
Essential Reading
Magazine/Newspaper Articles/Letters
Adverts and Sales Brochures
The Mighty Garage Videos
Bikes For Sale (Spares Company)
Log in
Register
What's new
New posts
Menu
Log in
Register
Install the app
Install
Home
Forums
Forums: Public Access
Tech. Advice: Series 'B' / 'C' 500cc/1000cc Bikes
Gudgeon (wrist) pin bush (little end bush)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="chankly bore" data-source="post: 40133" data-attributes="member: 317"><p>An old blacktracker showed me this method. Get a 1/2" diameter bolt about 3.5" long and a heavy plain washer. Get a socket deep enough to hold the old bush and just wide enough to bear on the con-rod eye. Place washer and new bush under bolt head put bolt through small end. Place socket over other end of small end bush, bearing on the con-rod eye. Fit nut and screw down, being careful to centralise new bush, which pushes old bush out. Then you need to take it to a good engineer to line-bore it parallel to the big-end after cheking the rod for twist, bend and cracks. How did the seat foam go?</p></blockquote><p></p>
[QUOTE="chankly bore, post: 40133, member: 317"] An old blacktracker showed me this method. Get a 1/2" diameter bolt about 3.5" long and a heavy plain washer. Get a socket deep enough to hold the old bush and just wide enough to bear on the con-rod eye. Place washer and new bush under bolt head put bolt through small end. Place socket over other end of small end bush, bearing on the con-rod eye. Fit nut and screw down, being careful to centralise new bush, which pushes old bush out. Then you need to take it to a good engineer to line-bore it parallel to the big-end after cheking the rod for twist, bend and cracks. How did the seat foam go? [/QUOTE]
Insert quotes…
Verification
What was Mr Irving's Christian Name?
Post reply
Home
Forums
Forums: Public Access
Tech. Advice: Series 'B' / 'C' 500cc/1000cc Bikes
Gudgeon (wrist) pin bush (little end bush)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top