On the spark plug thingy ?, There is a screw on the side of the tube, Maybe if loose you can alter the depth ??.
These things are very handy, Don't get rid of them, You won't use them for years,
Then one day !, Just the job !.
I have a 1 inch, 2 inch and a 4 inch, Just found a longer pin that screws into the 2 inch to make it a 1 inch,
All clever stuff.
If you use the dial thingy for TDC, Don't forget the Piston stays at TDC for few degrees,
The way to do it is to take a reading, Say an inch either side of TDC and with a degree wheel find the middle.
You don't tell us how old you are ?, Sorry if I am over doing it.
To hold the Mic' Put your little finger through the hole with the pin sticking upwards so you can turn the pin
with your thumb and first finger.
If you do take the plunge, Danno, the combined Lathe/ Mill from Machine Mart is a useful piece of kit for the beginner. Cheers, Stu.Thanks for the advice. Got a fair few obscure tools knocking around and enough, short of a metal turning lathe, to keep the Vin on the road. Lacking a pillar drill too
but someone advised that a hobby mill machine would be a better bet.
If you do take the plunge, Danno, the combined Lathe/ Mill from Machine Mart is a useful piece of kit for the beginner. Cheers, Stu.
I guess House Clearance after a Chap has Passed,