• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

E10 - Gudgeon Pin Circlip Install Tool

Alan J

Well Known and Active Forum Website User
VOC Member
Bruce-Seager type circlips are better in my opinion!! and easier to fit!! Maybe that gadget will work a treat or maybe not!! over the years I have bought all sorts of "gadgets" and most of them just end up in the bin!
 

bmetcalf

Well Known and Active Forum Website User
VOC Member
Most Seeger clips I have seen are stamped with one sharp or, at least square, edge. I don't know if even putting the round edge outwards would eliminate all problems. I have since seen on the Interweb a homemade similar device made from a 3/4" copper pipe solder coupling and a 5/8" deep socket. Those sizes might not be right for the Vin circlip diameter, though.
 
Warning! This thread is more than 10yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top