• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Craven Pannier Seat Frame Tab; Need Dimensions

minivin

Well Known and Active Forum Website User
VOC Member
Does anyone have the dimensions of the tab that fits to the top of the seat stays and is bolted all of two inches lower onto the "Z" form stay that goes from the front seat pivot, to the front pannier mounts?. My stays are unfortunately missing these two tabs, which is causing me a major headache at present.
 

minivin

Well Known and Active Forum Website User
VOC Member
Scrub that, I just found them. For information they are as follows:

3/4" x 2 1/4". 1/8" Mild Steel Strip.
1/4"Dia holes both ends, 7/16" in from the ends.
1/8" joggle, at 1 1/8" from one end, finishing at 1 1/2".
 
Warning! This thread is more than 10yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top