Hi All, The Comet I purchased unfortunately came without a dynamo armature fitted (just an empty dynamo frame), it does have a seal fitted where the armature would have protruded into the timing chest.
The previous owner promised an armature but none forthcoming.... the problem I have is:
(a) because I don't have an armature I cannot be sure the seal is the correct one
(b) I have now puchased an Alton alternator that has a sleeve on the rotor (I assume to bring the rotor shaft up to the size of the seal) but the outside diameter of the sleeve is too small to suit the seal?
(c) I noticed that E224 Dynamo Boss Seal is not listed by either VOC spares or Vintech.
Can anyone tell me if the original seal should fit the Alton, If so, from where may I purchase these seals.
If a different seal is required, does anyone have a Part No and supplier please.
Regards from a head scratching
Kevin Dennis
The previous owner promised an armature but none forthcoming.... the problem I have is:
(a) because I don't have an armature I cannot be sure the seal is the correct one
(b) I have now puchased an Alton alternator that has a sleeve on the rotor (I assume to bring the rotor shaft up to the size of the seal) but the outside diameter of the sleeve is too small to suit the seal?
(c) I noticed that E224 Dynamo Boss Seal is not listed by either VOC spares or Vintech.
Can anyone tell me if the original seal should fit the Alton, If so, from where may I purchase these seals.
If a different seal is required, does anyone have a Part No and supplier please.
Regards from a head scratching
Kevin Dennis