• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Cable routing - Comet

Martyn Goodwin

Well Known and Active Forum Website User
VOC Member
What is the correct way - that is how was it done originally, to route all of the control cables on a "C" Comet?

The brake and carb cables are obvious however I am very uncertain as to how to correctly route the clutch and decompressor cables. Exactly how should they be positioned?

Thanks,

Martyn
 

craig

Well Known and Active Forum Website User
VOC Member
also see photo - looks like both clutch and lifter cable rout down UFM left side - period cables were much more flexible and fragile.
the wire harness goes over top of F106, see two fuel hose go to a "Y" banjo, oil line going up to valves, spark wire John Bull attached to oil line. Also see - Comet pages at http://thevincent.com/comet-pages.html
1953CometSeriesC.jpg
 
Last edited:
Warning! This thread is more than 10yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top