• Welcome to the forum website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Online Forum Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this forum website.

    If you have previously registered to use this forum website, you should log in now. CLICK HERE.

    If you have never registered to use this forum website before, please CLICK HERE.

Adapter plate for regulators

Edwin Saxton

Forum Website User
Non-VOC Member
I need an adapter plate in order to fit a Podtronics regulator in the same position as a Miller regulator would fit on a Twin. Any ideas chaps?
 

bmetcalf

Well Known and Active Forum Website User
VOC Member
Apologies for the grime, but it is an aluminum bar with countersunk holes and tubular aluminum spacers for the dynamo clamp screws offset from through holes for the reg screws.

Reg Mounting.jpg
 

roy the mechanic

Well Known and Active Forum Website User
VOC Member
Here's what I did, take a peice of 5/16 (8mm) alloy plate, shape it to suit the base of the new reg. drill to suit the holes in the dynamo clamp, you have a choice here- either countersink the holes so the fixing screws sit flush with the top surface, or using a suitable milling cutter so the allen bolts sit flush . Align the reg to the mountin adaptor, drill + tap according, bolt=on, rewire according, Roy.
 

Bazlerker

Well Known and Active Forum Website User
VOC Member
I took a piece of 1" thick aluminum, drilled 4 holes, 2 countersunk on top, 2 countersunk on the underside..
 
Warning! This thread is more than 10yrs ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Top